To Next Page

To Previous Page

CONFIGURING WEBTOOLS

WebTools allow you to manage your Fiery EXP4110 remotely from the Internet or from your

company’s intranet. The Fiery EXP4110 has its own home page, from which you can select

the WebTool that you want to use.

For information about using WebTools, see Utilities.

Conﬁguring the Fiery EXP4110 and clients for WebTools

WebTools provide access to many Fiery EXP4110 functions via the Internet (or intranet),

providing additional ﬂexibility in remote management. After they are enabled, you can access

the WebTools from a network computer.

TO SET UP WEBTOOLS ON THE FIERY EXP4110

1 In Fiery EXP4110 Network Setup, enable TCP/IP.

2 Set a valid, unique IP address, subnet mask, and gateway address (if required) for the

Fiery EXP4110.

3 Enable Web Services.

4 In Fiery EXP4110 Printer Setup, conﬁrm that the Print queue is published.

TO SET UP WEBTOOLS ON A COMPUTER

1 Enable TCP/IP networking.

2Assign the workstation a valid, unique IP address, subnet mask, and gateway address,

if required.

3 Install an Internet browser that supports the Java language and frames.

Make sure Java is enabled. For more information about supported browsers and WebTools

requirements, see Welcome.

TO ACCESS WEBTOOLS

1 Start your Internet browser and type the IP address of the Fiery EXP4110.

The Fiery EXP4110 home page appears.

2 Click the tab corresponding to the WebTool.

Xerox 4110 Configuration And Setup

Other manuals for Xerox 4110