To Next Page

To Previous Page

SETTING UP THE FIERY EXP4110 FROM THE CONTROL PANEL

LPD Setup options

Enable LPD

Yes/No [Yes]

Select Yes to allow lpd printing.

PServer Setup options

NOTE: If you do not use PServer Setup, continue with the remaining Service Setup menus

starting with “Windows Setup options” on page 48.

Enable PServer

Yes/No [No]

Select Yes if you have a Novell network connected to the Fiery EXP4110.

Choose NDS Setup if your network uses NetWare in native mode. Choose Bindery Setup if

your network uses NetWare in bindery emulation mode.

If your network uses both NDS and Bindery, set up NDS ﬁrst. If you set up NDS after

Bindery, you will overwrite Bindery Setup.

NOTE: If your network uses both NDS and Bindery, and uses NetWare servers in bindery

emulation, the Fiery EXP4110 cannot service NDS and bindery emulation servers on the

same NDS tree.

NDS Setup

Before entering NDS settings, make sure the Fiery EXP4110 is connected to the network and

that you have conﬁgured an NDS directory tree with a Printer, Print Server, and one or more

Print Queue objects for Fiery EXP4110 jobs (see page 12). To perform NDS Setup, you may

need permission to browse the NDS tree. If access to the Print Server is restricted, you must

have a logon password.

Network Setup

Service Setup

LPD Setup

Network Setup

Service Setup

PServer Setup

Network Setup

Service Setup

PServer Setup

Xerox 4110 Configuration And Setup

Other manuals for Xerox 4110