Xerox Color J75 Press - Page 198

A jam notification is displayed on the UI.
• A jam occurred during feeding.
Remedy: Perform the following:
Carefully remove all sheets and paper scraps from the jam clearance areas.
Close the front door. Verify the paper used is within the approved paper specifications.
• Open the Interface Module front door.
048-103
Cause: Paper jam:
A jam notification is displayed on the UI.
• A jam occurred during feeding.
Remedy: Perform the following:
Carefully remove all sheets and paper scraps from the jam clearance areas.
Close the front door. Verify the paper used is within the approved paper specifications.
• Open the Interface Module front door.
048-300
Cause: The Interface Module front door is open.
Remedy: Close the Interface Module front door.
048-310
Cause: Interface Module decurler sensor or belt problem
Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-311
Cause: Interface Module decurler sensor or belt problem
Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-312
Cause: Interface Module decurler sensor or belt problem
Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-313
Cause: Interface Module decurler sensor or belt problem
Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-314
Cause: Interface Module decurler sensor or belt problem
Xerox
®
Color J75 Press13-10
User Guide
Interface Module