049-973
Cause: HCS falsely detects that the Paper Unload button is pressed.
Remedy: Perform the following:
Power Off/On the machine
If the problem still exists, contact the Customer Support Center.
• Open the HCS front door.
• Remove any paper from the stacker cart.
• Close the HCS front door.
Specifications
Paper guidelines
• Stacker Tray will accept 55-350 gsm (either coated or uncoated stock) with the
possibility of degraded stock quality and increased jam rate for stocks that are heavier
than 300 gsm.
• Transparencies may be run to either the Top Tray or the Stack Tray. Stack height
should be limited to 100 transparencies.
• Coated paper lighter than 100 gsm may not run as reliably as coated paper heavier
than 100 gsm.
• Non-standard papers longer than 305 mm (12 in.) in the feed direction require 210
mm (8.3 in.) minimum measurement across the feed direction.
• Non-standard papers shorter than 254 mm (10 in.) in the cross-feed direction require
330 mm (13 in.) minimum measurement in the feed direction.
Xerox
®
Color J75 Press14-26
User Guide
High Capacity Stacker (HCS)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
