Xerox Color J75 Press - Page 199

Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-315
Cause: Interface Module decurler sensor or belt problem
Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-316
Cause: Interface Module decurler sensor or belt problem
Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-317
Cause: Interface Module cooling fan failure
Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-318
Cause: Interface Module cooling fan failure
Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-319
Cause: Interface Module cooling fan failure
Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-320
Cause: Interface Module communication failure or connection failure
Remedy: Perform the following:
• Check the connection between the Interface Module and the connected finishing
device or devices.
• Fully clear any jams between the Interface Module and the connection finishing
device or devices.
• Ensure all jam clearance handles/levers are returned to their closed positions.
• After clearing all jams, remove any ejected paper from the finishing output area.
• Power Off/On the machine.
048-321
Cause: Interface Module communication failure or connection failure
Remedy: Perform the following:
• Check the connection between the Interface Module and the connected finishing
device or devices.
13-11Xerox
®
Color J75 Press
User Guide
Interface Module