Faxing
ColorQube 9301/9302/9303 Multifunction Printer 151
System Administrator Guide
1. In CentreWare Internet Services, click Properties > Services.
2. Click Server Fax > Fax Repository Setup.
3. Select NetWare from the Protocol menu.
4. Type the Repository Server, Server Volume, NDS Tree, NDS Context, and Document Path in the
provided fields.
5. Under Login Credentials to Access the Destination, select one of the following:
Authenticated User and Domain: The printer uses the domain name, user name, and password
of the authenticated users to access the server.
Authenticated User: The printer uses the user name and password of the authenticated user to
access the server.
Prompt at User Interface: Users type the login name and password at the control panel. Select
this option if you do not have an authentication server. Select this option if your document
repository requires different login credentials than the ones required to access the printer.
System: The printer uses the information provided in the Login Name and Password fields to
access the server.
6. Type the Login Name and Password if the system directly accesses the file server.
7. Click Apply to save the new settings or Undo to retain the previous settings.
Configuring Server Fax General Settings
1. In CentreWare Internet Services, click Properties > Services.
2. Click Server Fax > Defaults.
3. Under General, click Edit.
4. Select the User Name and Domain fields if you want these to display on the Job Log. The Job Log is
filed in the fax repository with the fax job.
5. To print a Confirmation Sheet after every Server Fax job, select On from the menu. The Confirmation
Sheet specifies the success or failure of the Server Fax job. If the fax is successful, the location of the
document on the fax server is also specified.
6. Click Save to apply the new settings or Undo to retain the previous settings.
Configuring Server Fax Settings
1. In CentreWare Internet Services, click Properties > Services.
2. Click Server Fax > Defaults.
3. Under Server Fax, click Edit.
4. Set the desired parameters.
5. Click Apply to save the new settings or Undo to retain the previous settings.
To Next Page
Loading...
Need help?
General
