Xerox ColorQube 9301 System Administrator Guide

Initial Setup
ColorQube 9301/9302/9303 Multifunction Printer 19
System Administrator Guide
Physical Connection Settings
You can specify Ethernet and USB settings, such as Ethernet Rated Speed, USB Connection Mode, and
Print Timeout for USB printing.
Setting Ethernet Options
1. In CentreWare Internet Services, click Properties > Connectivity > Physical Connections.
2. Click Ethernet.
3. Under Rated Speed, click the down arrow and select the speed of your connection.
4. Click Apply to save the new settings or Undo to retain the previous settings.
Click Default All to reset settings to default values.
Note: Restart the printer for the new settings to take effect.
Setting USB Options
1. In CentreWare Internet Services, click Properties > Connectivity > Physical Connections.
2. Click USB Settings.
3. Under USB Connection Mode, select an option:
 Software Tools: Select this option if you are using Xerox
®
Copier Assistant, or if you want to
disable Direct Printing via Driver. Xerox representatives also use this option to connect directly
to the printer and use diagnostic software and other software utilities.
 Direct Printing via Driver: Select this option to allow users to connect to the printer using a USB
cable.
4. Under Print Timeout, type the amount of time in seconds that the printer waits inactive before
disconnecting from a device connected to the port. Type 0 to disable the timeout.
5. Click Apply.

Xerox ColorQube 9301 Specifications

General

Brand	Xerox
Model	ColorQube 9301
Category	All in One Printer
Language	English