Power Saver/Energy Saver mode
The Power Saver/Energy Saver feature sets the time that lapses until the machine enters
a reduced power consumption mode. There are two power saver modes: Low Power and
Sleep. The modes are activated when all copy and/or print jobs are completed and there
are no jobs currently processing.
Low Power mode
In this mode, the power to the UI and fuser unit is lowered to save power. The display
goes out, and the Energy Saver button on the control panel lights up. To use the machine,
press the Energy Saver button. The Energy Saver button light turns off, indicating that
the Power Saver feature is canceled.
Sleep mode
In this mode, the power is lowered more than in the Low Power mode. The display goes
out, and the Energy Saver button on the control panel lights. To use the machine, press
the Energy Saver button. The Energy Saver button goes out to indicate that the Energy
Saver feature is canceled.
Set/change the Energy Saver mode time intervals
Note
The time intervals for both the Low Power and Sleep modes may be changed to reflect
a value of 1-240 minutes for each mode.
1. Log in as the administrator.
2. Press the Machine Status button on the control panel.
3. Touch the Tools tab on the UI.
The UI displays the System Settings screen.
4. Select System Settings > Common Service Settings.
5. Select Machine Clock/Timers.
6. Select Energy Saver Timers.
7. Select Change Settings.
8. Select the desired time interval for both the Low Power and Sleep modes.
Note
For D110/D125/D136 configurations, the default time for Low Power mode is 15
minutes, and the default time for Sleep mode is 60 minutes. For the D95 configuration,
the default time for Low Power is 5 minutes, and the default time for Sleep mode is
20 minutes. Ensure that the Sleep mode interval is configured with a longer amount
of time than the Low Power mode time interval.
1-3Xerox
®
D95/D110/D125/D136 Copier/Printer
System Administration Guide
Administrator overview
To Next Page
Loading...
Need help?
General