DocuMate 250 Scanner User’s Guide 13
Installation
Step 3: Connect the Power Supply
Connect the power supply and power cord, and plug the power
supply into an electrical outlet.
To connect your DocuMate 250 scanner:
1. Plug the power supply into the power port on the scanner.
2. Plug the power cord into the power supply and into a wall
outlet.
Now proceed to the next section, “Step 4: Connect the USB
Cable and Turn on the Power”.
NOTE: Only use the power supply (HEG42-240200-7L made by
HiTron) included with your scanner. Connecting any other type
of power supply may damage your scanner, and will void its
warranty.
To Next Page
Loading...
