Xerox
®
DocuMate
®
5445 / 5460
User’s Guide
146
Move, Resize, or Delete Regions
Moving regions – to move a region, place your mouse cursor over the region you want to move. The region will
highlight indicating that it is the active region under the mouse cursor. Click on the region and drag the mouse to
move the region.
Resizing regions – to resize a region, place your mouse cursor over the edge of the region outline. The cursor will
change to a dual directional arrow. Click on the line and drag the mouse to resize the region. If you click on the top
or bottom edge, you can only resize the region up or down. If you click on the left or right edge, you can only resize
the region left or right. Click on a corner edge and then drag the mouse to resize the region in all directions.
Note that you can only resize the scan regions to be within the scanner’s minimum and maximum supported paper
sizes. Please refer to the scanner specification table, in the maintenance section of the user guide, for the supported
paper sizes for your scanner.
To Next Page
Loading...
