Xerox
®
DocuMate
®
6460 / 6480 Scanner Setup
6 User Guide
4. Open the automatic document feeder cover and remove any tape or protective foam from
inside the feeder. Close the feeder cover when you are finished.
The above illustrations are for example purposes only. Your scanner’s packaging may vary slightly.
5. Slide the release switch in the output tray if you want it to lay flat on the desk.
Connect the Power Cord
Note: Only use the power supply (DA-48M24 made by APD) included with your scanner.
Connecting any other type of power supply may damage your scanner, and will void its warranty.
1. Plug the power supply into the power port on the scanner.
2. Plug the power cord into the power supply and into a wall outlet.
To Next Page
Loading...
