Before using the machine
1 - 6
1
For power & earth connection
Two power specifications are listed below. The specifications that apply to your machine depend on
your machine configuration. Connect the power plug only to a properly rated power outlet. Otherwise,
it can cause fire or electric shocks. If in doubt, contact our Customer Support Centre or your dealer.
• Rated voltage 100 to 120 V, 8.6 A
Rated frequency 50/60 Hz
• Rated voltage 220 to 240 V, 4.3 A
Rated frequency 50/60 Hz
Ensure that the plug connection is free of dust. In a damp environment, a contaminated connector can
draw a non-negligible amount of current that can generate heat and eventually cause fire over an
extended period of time.
Do not attempt to rework, pull, bend, chafe, or otherwise damage the power cord. Do not place a heavy
object on the cord. A damaged cord can cause fire or electric shocks.
Never touch a power cord with wet hands. Danger of electric shock exists.
Stop operation immediately if your machine produces smoke, excessive heat, unusual noise, or smell,
or if water is spilt onto the machine. These conditions can cause fire. Immediately switch off and
unplug the machine, and contact our Customer Support Centre.
Plug the power cord directly into a grounded electrical outlet easily accessible. Do not use an
extension cord. If you do not know whether an outlet is grounded, consult a qualified electrician.
Improper connection of the equipment-grounding conductor can result in an electric shock.
If the power cord is broken or insulated wires are exposed, ask our Customer Support Centre or your
dealer for a replacement. Using a damaged cord can cause fire or electric shocks.
Use only the power cord specified for this printer. Using a different cord may cause fire or electric
shock. Do not use the machine’s power cord on any other equipment.
Do not unplug or replug the machine while it is on. Unplugging a live connector can deform the plug
and cause fire.
To Next Page
Loading...
