Xerox Phaser 3020

June 2014
4-17
Xerox® Phaser® 3020 Printer Service Manual
REP 1.11
Repairs
Figure 5 Retard Pad Removal (Rear View)
Replacement
NOTE: Tapered Plastic Screws and Round Machine Screws are used to hold the PWB to the
frame. Make sure that the Plastic Screws go into plastic components and Machine Screws go
into the metal frame.
Install the components in the reverse of removal.
When replacing the Retard Pad make sure the Spring is positioned on the locating post on the
frame (Figure 5).
When replacing the Feed Rolls Assembly make sure the Locating Pins are positioned in the
frame holes before installing the screws (2) (Figure 6).
Figure 6 Feed Rolls Assembly Locating Pins (Top View)
Spring
Latches
Locating Pins