Xerox Phaser 3020

June 2014
4-24
Xerox® Phaser® 3020 Printer Service Manual
REP 1.16, REP 1.17
Repairs
5. Release the latch and remove the Feed Clutch (Figure 2).
Figure 2 Feed Clutch Removal (Left View)
Replacement
NOTE: Tapered Plastic Screws and Round Machine Screws are used to hold the PWB to the
frame. Make sure that the Plastic Screws go into plastic components and Machine Screws go
into the metal frame.
Install the components in the reverse of removal.
NOTE: Make sure the Feed Drive Shaft engages the Feed Roll Assembly.
REP 1.17 Paper Drive Roll and Drive Gear
Parts List on PL 3.3
Removal
1. Switch Off the Printer and unplug the Power Cord.
2. Remove the following covers:
a. Left and Right Side Covers (REP 1.2).
b. Rear Cover (REP 1.3).
NOTE: When removing the Main Drive Unit make sure the gears do not slide off their shafts.
3. Remove the Main Drive Unit (4 screws) (Figure 1).
Figure 1 Main Drive Unit (Left View)
Latch
Screws