3.After releasing the 2 hooks from the right side of the
frame,take out the transfer roller.
(Screw x 2:Silver-M3,6003-000196)
4.Remove the solenoid-MP by releasing the screw
from the left side of the frame.
(Screw x 1:Gold_M3,6003-000301)
5.2.12 Pick_Up Roller
1.For separating the pick-up roller sponge, open the
front cover, and then take out the toner cartridge.
2.While pressing the hooks on the left/right side of the
pick-up housing B, pull out the pick-up housing U as
shown as below.Then,replace the sponge.
To Next Page
Loading...
