Xerox Phaser 3117 Service Manual

x
Service Manual
Troubleshooting
6-10
6.3.6 Cover Open
• Description
The ERROR lamp is on even when the print cover is closed.
Check and Cause Solution
1. The Hook Lever in the top cover may be defective.
2. Check the connector (Engine B’d↔HVPS) and circuit of
the cover switch department in the Main Control board.
Perform DCU mode : If Error state '64' occurs, Check the
related codes of the Cover Open Error.
1. Replace the hook lever, if defective.
2. Check the insertion of the Cover Open S/W
Connect.
3. Replace the Main Control board or Cover Open
S/W.
6.3.7 No lamp on when the cover is open
• Description
The ERROR lamp does not come on even when the printer cover is open
Check and Cause Solution
1. Check the connector and circuit of the cover switch
department in the Main Control board. Perform DCU
mode : If Error state '64' occurs, Check the related codes
of the Cover Open Error
1. Check the insertion of the Cover Open S/W
Connect.
2. Replace the Main Control board or Cover Open
S/W.

Xerox Phaser 3117 Specifications

General

Print Technology	Laser
Print Speed	Up to 17 ppm
Paper Capacity	150 sheets
Connectivity	USB 2.0
Processor	150 MHz
Memory	8 MB
Paper Handling Output	100 sheets
Print Resolution	600 x 600 dpi
Media Sizes Supported	A4, Letter, Legal, Executive, A5, B5
Supported Operating Systems	Windows, Mac OS, Linux
First Page Out Time	Less than 10 seconds