4. Remove and replace the nudger roll using the same technique.
5. Remove and replace the retard roll using the same technique.
6. Close the bypass tray cover.
7. Verify that the tray is operating correctly by feeding paper from the bypass tray.
8. Either log in as the administrator or ask the administrator to perform the following
steps to reset the HFSI count to zero (0):
a) At the Control Panel, press the Tools button.
b) From the screen that displays, select the Tools icon.
c) Select System Settings > Common Service Settings > Maintenance.
d) Use the up/down arrow buttons to access the next Maintenance screens.
e) Select the Technical Key Operator icon. The Technical Key Operator feature
displays.
Xerox
®
Versant™ 2100 Press5-4
Quick Start Guide
Maintenance
To Next Page
Loading...
