Xerox Versant 2100 Press - Replacing the OHCF Feed Rolls

f) Select the MSI rolls item that corresponds with the newly-replaced components.
g) Select Reset Current Value. The system resets the HFSI to 0.
9. Exit the administrator mode by pressing the Log In/Out button on the Control Panel.
When prompted, select Logout.
Replacing the OHCF Feed Rolls
The OHCF feed rolls should be replaced every 300,000 prints or when experiencing
frequent multifeeds, single feeds, or blank prints in the stack of the output prints.
Use this procedure to replace the OHCF feed rolls, which includes:
• Feed Roll
• Nudger Roll
• Retard Roll
Note
After you replace all of the feed rolls, contact your system administrator who will reset
the HFSI usuage counter for these CRU components to zero (0).
1. Pull open the top tray of the OHCF to access the feed components.
5-5Xerox
®
Versant™ 2100 Press
Quick Start Guide
Maintenance