9. Replace a new retard roll into the black notches of the assembly using the same
technique.
10. Reinstall the retard assembly into the tray. Align the cutout holes of the assembly
with the frame of the tray so the pin holes match up. Insert the assembly into the
frame. Slide the assembly all the way to the right using the pin as a guideline. Ensure
the device is all the way into the slots and the 3 screw areas align.
11. Screw in the 3 thumbscrews to attach the assembly. Do not overtighten.
12. Close the tray and verify that the tray is operating successfully by feeding paper
using that tray.
13. Either log in as the administrator or ask the administrator to perform the following
steps to reset the HFSI count to zero (0).
a) At the Control Panel, press the Tools button.
b) From the screen that displays, select the Tools icon.
c) Select System Settings > Common Service Settings > Maintenance.
d) Use the up/down arrow buttons to access the next Maintenance screens.
5-9Xerox
®
Versant™ 2100 Press
Quick Start Guide
Maintenance
To Next Page
Loading...
