7. Attach the appropriate jumper to the exposed white connector at the front of the
fuser assembly by pushing the two ends together. There is no release. To disconnect,
simply pull apart.
8. Position the fuser cover back on the assembly and screw tightly in place.
9. Close both front doors of the press.
10. If the paper in the print job does not match the width set for the fuser, an error
message displays and the job will not print. Cancel the job and submit the correct
paper width for that job or install the correct width range fuser.
Xerox
®
Versant™ 2100 Press5-34
Quick Start Guide
Maintenance
To Next Page
Loading...
