b. Continue slowing pulling out the bottle from the press until it is completely removed.
Caution: Never use a vacuum cleaner when cleaning up any spilled dry ink / toner. Use
a broom or a cloth moistened with a neutral detergent.
5. Place the full waste bottle into the plastic bag provided with the bottle.
6. Remove a new, empty waste bottle from the packaging.
7. Hold the center part on the top of a new bottle and insert it gently into the press until it comes to
a stop.
8. Close the center front door.
Note: After you replace the dry ink/toner waste bottle, the system automatically resets the
High Frequency Service Item (HFSI) usage counter for this CRU component to zero (0).
Check the consumables Supply screen to verify the reset.
Xerox
®
Versant
®
4100 Press
Quick Start Guide
39
Maintenance
To Next Page
Loading...
