EasyManuals Logo

Xerox WorkCentre 5016 User Manual

Xerox WorkCentre 5016
133 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #116 background imageLoading...
Page #116 background image
Cleaning the Machine
Xerox WorkCentre 5016/5020 User Guide 116
Cleaning the Machine
The cleaning instructions are specific to each part of the machine, such as the machine
exterior, Document Cover, Document Glass, Film, Constant Velocity Transport Glass,
Document Feeder Roller, and Corotron Wire.
This section describes how to clean each component of the machine.
Cleaning the Exterior
The following describes how to clean the exterior of the machine.
Important Always switch off the power to the machine, and unplug the power cord before cleaning
any part of the machine. Cleaning the machine with the power on may cause an electric
shock.
Do not use any volatile liquids on the machine such as benzene and paint thinner, or insect
repellent as these may discolor, deform, or crack the machine exterior.
Cleaning the machine with an excessive amount of water may cause the machine to
malfunction, or damage documents being copied.
1.
Wipe the exterior with a soft cloth
moistened with water.
Important Do not use cleaning agents other
than water or neutral detergent.
Note If dirt does not come off easily,
gently wipe it with a soft cloth
moistened with a small amount of
neutral detergent.
2.
Wipe off any excess water with a soft
cloth.
Cleaning the Document Cover and Document Glass
If the Document Cover and Document Glass are dirty, streaks or smears may appear
on copies, or the machine may not properly detect the size of the original documents.
The following procedure describes how to clean the Document Cover and the
Document Glass.
Important Do not use benzene, paint thinner, or other organic solvents. Doing so might damage paint
or coating on plastic parts.
Cleaning the machine with an excessive amount of water may cause the machine to
malfunction, or damage documents being copied.
1.
Wipe the Document Cover with a soft
cloth moistened with water to remove
any dirt and then wipe it with a soft, dry
cloth.
Important Do not use cleaning agents other
than water or neutral detergent.
Note If dirt does not come off easily,
gently wipe it with a soft cloth
moistened with a small amount of
neutral detergent.
2.
Wipe the Document Glass with a soft
cloth moistened with water, and then wipe it with a dry cloth.
Important Do not use cleaning agents other than water or neutral detergent.
Document
Cover
Document
Glass
Downloaded From ManualsPrinter.com Manuals

Table of Contents

Other manuals for Xerox WorkCentre 5016

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 5016 and is the answer not in the manual?

Xerox WorkCentre 5016 Specifications

General IconGeneral
Print Resolution600 x 600 dpi
Copy Resolution600 x 600 dpi
Fax Transmission Speed33.6 Kbps
Duplex PrintingManual
FunctionsCopy, Print, Scan
Print TechnologyLaser
Print Speed16 ppm
Copy Speed16 cpm
Scan TypeFlatbed
Scan Resolution600 x 600 dpi
Paper Capacity250 sheets
ConnectivityUSB 2.0
Monthly Duty Cycle10, 000 pages
Operating System CompatibilityWindows, Mac, Linux

Related product manuals