Switching On / Off
Xerox WorkCentre 5016/5020 User Guide 31
Switching On / Off
This section describes how to switch the machine on and off, and explains the Power
Saver feature.
The machine is ready within 27 seconds after the machine is switched on. The time
required for the machine to warm up may vary, depending on the machine configuration
and the machine environment.
The machine automatically enables the Power Saver feature during inactivity to
minimize power consumption. It is recommended to switch off the machine at the end
of the day or when it is not in use for a long period of time.
Important • Switching off the machine may cause loss of data currently being processed.
For information on the Power Saver feature, refer to "Power Saver" (P.32)
Switching On
The following procedure describes how to switch on the power to the machine.
1.
Press the Power Switch to the
[ ] position.
Note • [1] appears in the Display when
the machine is ready.
• If you attempt to run a job during
warm-up, the job will be processed
once the machine is ready.
Switching Off
The following procedure describes how to switch off the power to the machine.
Important • Switching off the machine may cause loss of data currently being processed.
1.
Before switching off the machine, make sure that all jobs have been processed
completely.
Important • Never switch off the machine in the following instances:
-While data is being received
-While jobs are being printed
-While jobs are being copied
-While jobs are being scanned
2.
Press the Power Switch to the [ ]
position.
Important • After pressing the Power Switch to
the [ ] position, wait for a few
seconds before removing the
power cord from the power outlet
until the machine powers off
completely.
• After switching off the machine,
wait for a few seconds before
switching the machine back on
again.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
