Xerox WorkCentre 5335 Administrator's Guide

Network Configuration
WorkCentre 5300 Series Multifunction Printer
System Administrator Guide
26
SNMP
Simple Network Management Protocol (SNMP) is used in network management systems to monitor
network-attached devices for conditions that require administrative attention. It consists of a set of
standards for network management including an application layer, a database schema, and a set of
data objects. Agents, or software modules, reside in the printer’s SNMPv3 engine. A manager is an
SNMPv3 management application such as OpenView, that is used to monitor and configure devices on
the network. The agent responds to read (GET) and write (SET) requests from the manager and can
also generate alert messages, or Traps, based on certain events.
SNMP settings can be configured in CentreWare IS. You can also enable or disable Authentication
Failure Generic Traps on the printer. SNMPv3 can be enabled to create an encrypted channel for secure
printer management.
Enabling SNMP
1. In CentreWare IS, click Properties > Connectivity > Port Settings.
2. Next to SNMP, select Enabled.
3. Select UDP and IPX to enable these transport protocols if necessary.
Configuring SNMP
1. In CentreWare IS, click Properties > Connectivity > Protocols > SNMP Configuration.
2. Under SNMP Properties, select Enable SNMP v1/v2c Protocols, or Enable SNMP v3 Protocol,
then click Apply.
Note: You must click Apply to save your settings or the protocol will remain disabled.
3. Under Authentication Failure Generic Traps, select Enabled if you want the printer to
generate a trap for every SNMP request that is received by the printer that contains an
invalid community name.
4. Click Apply. For details, see SNMP Advanced Settings on page 27.
Editing SNMP v1/v2c Properties
Note: Xerox recommends that you change the SNMP v1/v2c public and private community names
from the default values for security purposes.
1. In CentreWare IS, click Properties > Connectivity > Protocols > SNMP Configuration.
2. Under SNMP Properties, click Edit SNMP v1/v2c Properties.
3. Type a name up to 256 characters for the Community Name (Read Only) or use the default
value of public. GET returns the password for the SNMP GET requests to the printer. Applications
obtaining information from the printer using SNMP, such as CentreWare IS, use this password.

Xerox WorkCentre 5335 Specifications

General

Type	Multifunction Printer
Functions	Print, Copy, Scan, Fax
Print Technology	Laser
Print Speed (Black)	35 ppm
Print Resolution	1200 x 1200 dpi
Copy Speed	35 cpm
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Duplex Printing	Automatic
Memory (Standard)	1 GB
Scan Destinations	Email, Network Folder, USB
Fax Speed	33.6 Kbps
Monthly Duty Cycle	100, 000 pages
Hard Drive	80 GB
Connectivity	USB, Ethernet