Xerox WorkCentre 5335 Administrator's Guide

Network Configuration
WorkCentre 5300 Series Multifunction Printer
System Administrator Guide
28
5. Under Traps, select the type of Traps to be Received by the SNMP manager.
6. Click Apply.
Adding IPX Trap Destination Addresses
Internetwork Packet eXchange (IPX) is a routing protocol used by Novell NetWare environments.
1. In CentreWare IS, click Properties > Connectivity > Protocols > SNMP.
2. Click Advanced at the bottom of the page.
3. Under Trap Destination Addresses, click Add IPX Address.
4. Type the 8-digit hexadecimal number that identifies the IPX External Network host configured to
receive the trap.
5. Type the 48-bit Physical MAC Address of the computer running the SMNP manager application
that is to receive the trap.
6. Type the IPX Socket Number of the computer running the SNMP manager application configured
to receive the packets.
7. Select the SNMP version, SNMP v1 or SNMP v2c based on the trap receiving system.
8. Under Traps, select the type of Traps to be Received by the SNMP manager.

Xerox WorkCentre 5335 Specifications

General

Type	Multifunction Printer
Functions	Print, Copy, Scan, Fax
Print Technology	Laser
Print Speed (Black)	35 ppm
Print Resolution	1200 x 1200 dpi
Copy Speed	35 cpm
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Duplex Printing	Automatic
Memory (Standard)	1 GB
Scan Destinations	Email, Network Folder, USB
Fax Speed	33.6 Kbps
Monthly Duty Cycle	100, 000 pages
Hard Drive	80 GB
Connectivity	USB, Ethernet