Troubleshooting
WorkCentre 7800 Series Multifunction Printer 251
User Guide
3. Grip the staple cartridge by the orange tabs and pull it firmly toward you to remove it. Check inside
the finisher for any loose staples and remove them.
4. Pull the staple cartridge clamp firmly in the direction shown to open it.
5. Remove the jammed staples (1), then push the clamp in the direction shown until it snaps into the
locked position (2).
WARNING: The points of the jammed staples are sharp. Remove the jammed staples carefully.
6. Grip the staple cartridge by the orange tabs and insert it into the staple cartridge unit until it clicks.
7. Close the finisher front door.
To Next Page
Loading...
Need help?
General
