Infrared Recharge Sensor
12
Care & Maintenance
CAUTIONS:
• Do not rinse or soak the 2-in-1 water tank.
• Regularly clean the 2-in-1 water tank to avoid dirt affecting the cleaning performance.
1. Remove the 2-in-1 water tank, open the water tank lid and the dust
compartment cover to empty the contents, and then clean the 2-in-1 water
tank with the cleaning brush.
Cleaning the 2-in-1 water tank and filter
Remove the mop pad from its holder, then wash and dry it.
Cleaning the mop pad
2. Remove the filter and clean it with the cleaning brush.
Note: The filter can be rinsed with water. Make sure it is completely dry before re-installation.
Frequent rinses are not suggested.
Clean all sensors and charging contacts with a so cloth every 3 months.
Cleaning sensors and charging contacts
Cliff Sensor
Charging Contact
Laser Distance Sensor
To Next Page
Loading...
