Xilinx Virtex-6 FPGA Getting Started Guide

Virtex-6 FPGA Connectivity Kit Getting Started www.xilinx.com 49
UG664 (v1.4) July 6, 2011
Modifying the Virtex-6 FPGA Targeted Reference Design
InstallShield successfully uninstalls the previous driver for the Virtex-6 FPGA
Connectivity TRD. Click Finish to close the InstallShield Wizard (Figure 44).
6. Load recompiled drivers:
To install the recompiled drivers, run x_v6_trd_setup.exe again.
The InstallShield Wizard for the Virtex-6 FPGA Connectivity TRD is launched. Click
on Next until the InstallShield Wizard completes, and then click on Finish. At the end
X-Ref Target - Figure 44
Figure 44: InstallShield Uninstalls Drivers
UG664_74_060911

Xilinx Virtex-6 FPGA Specifications

General

Brand	Xilinx
Model	Virtex-6 FPGA
Category	Transceiver
Language	English