33
WS6
WIRELESS HEADPHONES
WS6 MASTER
Alternates coil charging level and
WS6
Name & Program No. (change with + -)
Decrease programs and values
Long press from main screen :
SHORTCUT to VOLUME
OPTIONS: Volume/Cong.
In Option long press: EXPERT
Mode
In Menu: Back
Long press from main screen :
SHORTCUT to GRAB
Indicates the link with the coil
Manual switch ON
Increase programs and values
Long press from main screen:
SHORTCUT GO TERRAIN PUSH
MENU : DISCRI/SENS/...
• Long press from menus: EXPERT
mode
• Long press from main screen: PIN-
POINT MODE
• From Option: backwards
F/NF (ferrous/non-ferrous) and target
strength
USB min. B charge and update.
Full WS6 manual at www.xpmetaldetectors.com
The WS6 are not just wireless audio headphones. Without the remote con-
trol, they can be a stand alone unit and connect with the coil for an extremely
ergonomic and lightweight conguration. The WS6 Module can be unclipped
and mounted on the stem to make the most of the control screen, the target
display and all the settings. It is then ideally supplemented by the WSA II or
WSAII XL wireless headphones.
WS6 - 3 Congurations
WS6 SLAVE
WS6 slave of the remote.
(965g with coil 22cm)
The remote control is master and
controls the coil, the functions and
the settings
Note: The WS6 can be replaced by the
WSAII/WSA II XL/BH-01 and FX03.
headphones
WS6 MASTER
(+ wireless headphones)
WS6 Master in a comfortable
conguration (810g with coil 22cm)
The WS6 controls the coil, adjusts all
the settings and displays the targets.
- Identical performance.
- Very detailed graphic screen.
- Connect the headphones WSA II/
WSAII XL/Wired, etc. to the WS6
WS6 MASTER
(WS6 only)
WS6 module clipped to the
backphones (750g with coil 22 cm).
The WS6 controls the coil, adjusts all
the settings and displays the targets.
- Identical performance.
- Very detailed graphic screen.
and
manual Switch OFF
WS6 SLAVE
When the WS6 is slave, only the volume can be adjusted, using
and
.
To pair the remote control when using it for the rst time, please refer to the chapter "Pairing headphones"
To move the WS6 from slave to master, it has to be re-started with the remote control switched OFF. It will
then operate as a master with your paired coil. Dont forget to pair them to the coil rst. OPTION > PAIRING
COIL (see WS6 manual online).
2 31
RC
WS6
WS6
WS6
WSAII
The remote control programs are separate from the internal WS6 programs. When using the WS6 inde-
pendently as a master (without remote control), the WS6 nds its original user programs, i.e. the remote
control programs are never transferred to the WS6.
and T.ID full screen
To Next Page
Loading...
Need help?
General
