XP DEUS II - Power Supply - Charging and Battery Lifetime; Charge Instructions; Lithium Polymer (LiPo) Battery Lifetime

38
The coil, remote control and headphones are powered by a Lithium battery (LiPo). Please use the mains
unit supplied that can charge the three components simultaneously using the lead-output cable.
A well-maintained LiPo battery can last ten years in your XP detector !
The Lithium Polymer batteries (LiPo) are designed to withstand hundreds of charges, thereby generating
signicant battery savings. As a guide, a ten-year lifetime can be envisaged when they are used correctly
on a weekly basis.
Battery lifetime is in your hands !
To extend the life of your batteries well beyond ve years, do not store them either at or fully charged for
a long time. Keep them half charged between 40 and 80%.
If you do not use your detector for several months, check them every two months by letting them go at
and then charging them to 40-80%.
Charge
Lithium Polymer (LiPo) battery lifetime
POWER SUPPLY - BATTERIES
The three components (coil/remote control/headphones) can be charged by any USB mains
unit 5 V/1 A minimum. Watch out for the quality of the charger and counterfeits, use a certied
model from a reputable brand carrying the following certication symbols:
Under no circumstances can XPLORER (XP METAL DETECTORS) be held liable for damage or
loss generated by using a defective charger or failing to comply with the certication standards
in force.
!
Output 5V
1 A or +
Output 5V
1 A or +
• Connect the USB plug to the power supply.
• Plug the round connector into the remote control and the two USB min. B to the headphone and charg-
ing clamp.
The coil is charged using the clamp supplied. Connect it along the ribs of the coil cover to ensure the
correct connecting direction and avoid a reverse polarity. The clamp output must be facing towards the
center of the coil as indicated below.