42
The coil does not switch on, unlike the remote control and the headphones
There is no detection sound in the headphones despite them being switched on
(and pressing the buttons generates an audible beep)
PROBLEMS and SOLUTIONS
CAUSES SOLUTIONS
The machine is over sensitive. Lower the sensitivity.
You are in a high EMI zone with a great deal of
interference (high-voltage power lines, electric
transformer, electric fence).
Lower the sensitivity, change or shift frequency.
Move to a different zone.
There is a storm nearby and the electromagnetic
discharges of lightning appears to be interfering
with the detector.
Switch off and wait for the storm to pass.
Never detect in a lightning storm.
You are close to other working metal detectors. Change or shift the frequency.
Soil effects are adjusted incorrectly. Adjust automatically (GRAB).
The ground is heavily infested with iron and oth-
er metals.
Find a less infested place - lower sensitivity
Do not practise in your garden !
CAUSES SOLUTIONS
You have the wrong coil selected in the menu:
OPTION/PAIRING COIL.
Select the correct coil.
The serial number of the coil that you have en-
tered in the remote control was incorrect or was
changed inadvertently.
Check the coil serial number entered or pair it again
automatically (see coil > pairing).
The battery is discharged. Recharge it. - check charging source.
The coil is defective. Contact your reseller.
CAUSES SOLUTIONS
If you are using the WS6 Master (without remote
control) you may have chosen an incorrect coil
in OPTION > COIL.
Select the correct coil.
The headphone has not been paired with the re-
mote control.
If you are using the WS6 Master (without remote
control), the headphones have not been paired
with the coil.
Pair them.
You become aware of abnormal performance, instability, false signals or interference, for no apparent reason
There is no sound in the headphones when passing over a target and
pressing the buttons generates no audible beep
CAUSES SOLUTIONS
The backphones are not working. The module has come away slightly from the head-
band. Clip it back in.
Or Change headband, it is easy to replace.
The module maybe faulty. Contact your reseller.
To Next Page
Loading...
Need help?
General
