39
Acceptable ambient temperature during charging: From 0°C to + 40°C maximum.
Recommended storage temperature: 25°C.
Batteries:
• The batteries are tted with internal protection systems which shield them from extreme overloads and
discharges. They must not be dismantled or short-circuited, which is dangerous and could destroy the
protection systems, explode or cause the batteries to ignite.
• Do not leave batteries on charge unnecessarily and disconnect the power adaptor when the charge
cycle is complete or after 3 hrs.
• If you notice any perforation, odour or other anomaly, please return the battery to the retailer in a sealed
plastic bag and do not try to charge again (risk of destroying the protection systems, explosion or causing
the batteries to ignite).
• Never dispose of lithium batteries with your household waste: return them to your XP retailer or take
them to a designated collection point.
• Do not place the batteries near heat sources and never throw them onto a re.
• Never perforate the battery cover or try to weld/solder the battery.
• Risk off explosion if battery is incorrectly replaced. Replacing the battery with another of the incorrect
type can lead to a risk of explosion. Only use LiPo batteries supplied by XP (ref.: D088M-WTUBE).
• If you notice abnormal overheating of components on charge, disconnect the mains unit immediately and
do not try to charge further.
Replacing batteries
Safety precautions
POWER SUPPLY - BATTERIES
The batteries for the wireless headphones (ref batterry : GMB452230 - ref XP : D088WS-WTUBE) and
the remote control (ref battery : GMB721945 - ref XP : D088M-WTUBE) are easy to replace. Unscrew the
rear/lower cap of the headphones or remote control / Remove the speaker from the Remote / Unclip the
battery and change it. Then screw the cap (taking care of the O-rings and speaker).
!
We highly recommend that you go through an authorized XP dealer to replace any of the detectors
batteries. breakages or defects (sealing, ...) caused by changing a battery or opening any part of the de-
tector will void the XP warranty.
BATTERY REPLACEMENT (ref battery : GMB721945 - ref XP : D088M-WTUBE) : The search coil battery
is sealed for obvious reasons - safety and impermeability. It must be returned to our service department
or an XP distributor for replacement.
• Remove the coil cover. Using a cutter, cut the battery cover along the inside groove, the battery cover is
the one with the battery logo
.
• Disconnect the out-of-service battery and remove it. Lithium batteries must be recycled appropriately or
returned to your retailer.
• Connect the new battery and inject silicon from the syringe onto the battery's white connector.
• Spread the adhesive from the kit on the compartment surround, insert the battery/cover assembly and
stick it down. Keep the cover in place with the clamp.
• Turn the coil over and make sure it is horizontal so that the liquid silicon can complete the seal. Leave
to dry for 24 hours.
• Lastly, deburr the surplus glue and reposition the coil cover.
A video explaining how to replace the battery can be viewed on the XP Internet site. The batteries carry
a two-year parts and labour warranty.
• Always connect your power adaptor in an accessible, visible place to ensure that it can be unplugged
quickly in the event of overheating or other problems.
• Do not charge unattended close to inammable parts.
• The power adaptor is only designed for indoor use and should not be exposed to water or humidity.
• Do not charge the devices during a thunderstorm and unplug the power adaptor from the supply.
• XP only guarantees electrical safety with the original mains unit or a certied USB mains unit :
Xplorer cannot be held liable for any consequences arising from a failure to comply with the precautions
for use.
Power adaptor
To Next Page
Loading...
Need help?
General
