9
Once the detector has indicated the approximate presence of
a target in Motion mode, sweep the place where you heard the
sound if you are having difculty locating the target. Slowly re-
duce the amplitude of your movements and make a mental note
of the spot where the sound is loudest. If necessary, indicate
it with a mark on the ground. Then move a quarter turn around
the spot and begin sweeping again in the same way (at 90° to
the rst sweep). You should then locate the precise zone con-
taining your target at the intersection of the two sweeps, where
the sound is loudest. Continue with crossed sweeps over the
target. The loudest and highest pitched audio signal indicates
the centre of the coil and therefore the position of the target.
You can also use non-motion mode, where the coil does not
need motion to register the target (see Chapter PINPOINT).
Locating a target using crossed sweeps
PRACTICAL INFORMATION
LIST OF PARTS
Box contents
1 remote + hipmount case.
1 set of wireless headphones with storage case (depending on version purchased).
1 search coil with coil cover (depending on version).
1 coil tting kit.
1 aerial antenna to use underwater + clip.
1 gray cap on the remote + 1 red cap for diving (see DIVING & SEALING).
1 S-TELESCOPIC Stem + lower stem (depending on version).
1 mains adaptor (depending on Country).
1 charging cable for three components and remote updates.
1 coil connection clamp.
1
2
3
4
5
9
6
10
7
8
7 9 10
2 3 41 5
6 8
To Next Page
Loading...
Need help?
General
