Instructions for XPENG Owners
9
1
2
3
4
5
6
7
8
9
10
11
1. 1. Ultrasonic radarUltrasonic radar
2. 2. High-precision millimeter wave radarHigh-precision millimeter wave radar
Radar MaintenanceRadar Maintenance
To ensure radars working properly, the radar must
be kept clean and free of ice, snow, water, dust,
and other foreign objects attached.
When a foreign object is found attached to the
radar surface, wipe it with a soft cloth or clean it
with water (low water pressure). Do not flush the
radar with a high
Caution
●
The front and rear-facing SRRs are
mounted in the front and rear bumpers
respectively. Therefore, to avoid affecting
their performance, it is strictly forbidden
to paint the bumpers or embed surrounds.
●
If the radar is damaged, please contact
XPENG Service Center for replacement or
repair.
Warning
●
It is forbidden to replace, refit, or add
radar without authorization, and only the
original or approved radar of XPENG can
be used. Otherwise, it may lead to some
abnormalities in the relevant functions,
but also radio interference, resulting in
direct or indirect damages, XPENG does
not assume any responsibility. When the
radar fails or needs to be replaced, please
contact the XPENG Service Center.
●
The radar does not work properly in all
driving situations or in trac, weather
and road conditions, so you should drive
carefully and always be responsible for
driving safely when your vehicle is in a
complex environment or in poor condition.
https://www.automotive-manuals.net
To Next Page
Loading...
Need help?
General
