Active Safety
218
Intelligent High Beam Control (IHB)Intelligent High Beam Control (IHB)
Function IntroductionFunction Introduction
The Intelligent High Beam function automatically The Intelligent High Beam function automatically
switches between high beam and low beam switches between high beam and low beam
based on information such as the ahead vehicle based on information such as the ahead vehicle
and environment light to avoid interference with and environment light to avoid interference with
surrounding trac participants.surrounding trac participants.
Caution
This function does not guarantee complete
and accurate perception of the surrounding
environment or vehicles, and it may cause mis-
adjustment of high and low beams. Please make
sure to comply with local trac regulations
and use this function in a proper way that is
required by law.
Function ActivatedFunction Activated
When the following conditions are met, IHB is When the following conditions are met, IHB is
activated, and the function automatically switches activated, and the function automatically switches
between high beam and low beam according to between high beam and low beam according to
the environmental conditions:the environmental conditions:
1. The intelligent high beam switch on the CID is 1. The intelligent high beam switch on the CID is
on;on;
2. The light switch is in AUTO;2. The light switch is in AUTO;
3. The low beam is activated;3. The low beam is activated;
4. The front windshield camera is not obstructed 4. The front windshield camera is not obstructed
or fogged;or fogged;
Note
After IHB is activated, if the vehicle speed
is less than 15 km/h, the IHB function be
deactivated.
To Next Page
Loading...
Need help?
General
