Preparations Before Driving
76
Initialization of Anti-Pinch FunctionInitialization of Anti-Pinch Function
When the window anti-pinch function is When the window anti-pinch function is
deactivated, try to initialize it as follows:deactivated, try to initialize it as follows:
1. 1. Power on the vehicle and doors are closed. Power on the vehicle and doors are closed.
Pull up the primary switch of the window Pull up the primary switch of the window
(at jog position) so that the window is fully (at jog position) so that the window is fully
closed and hold for 3 seconds, then release.closed and hold for 3 seconds, then release.
2. 2. Press the primary switch of the window (at Press the primary switch of the window (at
jog position) to lower the window to the jog position) to lower the window to the
automatic stop position, then release.automatic stop position, then release.
3. 3. Press the primary switch of the window (at jog Press the primary switch of the window (at jog
position) again to fully open the window and position) again to fully open the window and
hold for 3 seconds to complete the window hold for 3 seconds to complete the window
initialization.initialization.
The following operations to check for completion The following operations to check for completion
of initialization:of initialization:
1. 1. Press the secondary switch (at one-touch Press the secondary switch (at one-touch
lift position) and release it, the window can lift position) and release it, the window can
automatically drop to the fully open position.automatically drop to the fully open position.
2. 2. Pull up the secondary switch (at one-touch Pull up the secondary switch (at one-touch
lift position) and release it, the window can lift position) and release it, the window can
automatically rise to the closed position.automatically rise to the closed position.
Caution
●
Set the windows to be fully open and
closed within 15 seconds.
●
Setting the windows to fully open and
close must be completed consecutively.
If you only complete one of the steps,
the anti-pinch function may fail. Two
consecutive steps are required to avoid
this risk.
●
When the window is automatically closing,
if an obstacle is detected above the
window, it will automatically stop rising.
To Next Page
Loading...
Need help?
General
