6-6
GETTING STARTED
High Pressure Gas Hoses
You should only connect to this regulator
using a length of approved high-pressure
hose not exceeding 450mm from the gas
cylinder to the regulator. These approved
high-pressure hoses are available from your
Erwin Hymer Group UK Retailer. These
hoses are connected using screw thread
fittings, which will make a seal if connected
and tightened using a spanner. Once the
hose is securely connected turn on the gas
tap above the regulator, then turn on the gas
bottle to allow gas to flow into the caravan.
In order to make all your caravan gas
appliances operational it is necessary to
open each appliance gas tap as detailed in
previous column. All your gas appliances
should now be operational. Instructions on
how to use each appliance are detailed later
in your handbook.
WARNING: Aerosols and highly flammable
liquids must not be stored in the
compartment behind, or adjacent to, any
gas appliance. Some industrial LPG
appliances operate at high pressure and
require a ‘high pressure’ regulator. This
often has an adjusting handle on it.
NEVER use such a regulator on a caravan.
Ventilation holes must be clear at all
times.
To Next Page
Loading...