8-30
HOW TO USE YOUR CARAVAN’S EQUIPMENT
Fig 7. Choice of
energy sources
Heating with electricity
The consumption selected in the menu is the maximum consumption permitted, i.e. the boiler
does not use more power than is required, even if e.g. 3kW is selected in the Control Panel.
• Tap the “Max electricity” menu bar to open the electric power settings menu.
• Increase or decrease the maximum permissible electrical power between 0-3 kW using the
plus and minus buttons. 0 kW equals electric operation being switched off.
• Confirm your selection by pressing the “Set” button. Press “Cancel” to cancel.
Heating with gas
Tap the slider on the “Gas” menu bar to start and shut off gas operation. (Fig 7).
High altitude mode
High altitude mode is only to be used if the boiler will be powered by LPG at altitudes exceeding
1000m above sea level. For high-altitude LPG operation, use propane to ensure stable
combustion. Varied operating conditions at high altitudes may cause the boiler to not always
reach full gas operation. Tap the slider on the “High altitude mood” menu bar to start and turn
off throttle. (Fig. 7)
• “Boost”, (prioritised hot water production). Tap the slider to the
right of the text that reads “Boost 30 minutes”. The boiler will
now prioritise the production of hot water for 30 minutes. After
30 minutes have passed, the boiler returns to its previous
setting. Prioritised hot water production is recommended for
increased hot water demand.
Energy sources
The boiler can be powered either by gas or electricity or both at
the same time. The fastest heating is obtained by using both
energy sources at the same time as the overall power available
will be greater. Hence, more power, equals faster heating. It is
also possible to prioritise which energy source to use, when both
gas and electricity are switched on; in the event of high heat
demand, both are activated. When the boiler approaches the set
temperature, energy consumption is gradually reduced.
To Next Page
Loading...