What to do if my Xtreme TX91 UPS shows fault code 01, 02, 03, 04, 11, 12, 13, 14,1A, 21, 24, 35, 36, 41, 42 or 43?
If fault code 01, 02, 03, 04, 11, 12, 13, 14, 1A, 21, 24, 35, 36, 41, 42, or 43 appears on the LCD of your Xtreme UPS and the alarm is beeping continuously, this indicates an internal fault. In this situation, contact your dealer.
What to do if my Xtreme TX91 UPS is beeping twice every second?
If the icon flashes on the LCD display of your Xtreme UPS and the alarm beeps twice every second, it means the UPS is overloaded. Try the following: * Remove some of the devices connected to the UPS. * If, after repetitive overloads, the UPS is locked in Bypass mode, remove excess loads, then shut down the UPS and restart it.
What does fault code 43 mean on my Xtreme UPS?
If fault code 43 is displayed, the icon lights up, and the alarm beeps continuously on your Xtreme UPS, it indicates the UPS has been overloaded for too long and has become faulty, causing it to shut down automatically. To resolve this, remove some of the devices connected to the UPS and then restart it.
Why is the battery backup time shorter than expected on my Xtreme UPS?
If the battery backup time of your Xtreme UPS is shorter than expected, it could be due to the following reasons: 1. The batteries are not fully charged. Charge the batteries for at least 7 hours and then check their capacity. 2. The batteries are defective. In this case, contact your dealer to replace the battery.
What does fault code 14 mean on my Xtreme UPS?
If fault code 14 is displayed, the icon lights up, and the alarm beeps continuously on your Xtreme UPS, it indicates a short circuit on the UPS output. You should check the output wiring and the connected devices for any short circuit.
How to disable EPO function on Xtreme UPS?
If the icon and the warning code flash on the LCD display and the alarm beeps every second on your Xtreme UPS, it means the EPO (Emergency Power Off) function is enabled. To disable it, set the circuit in a closed position.
What to do if my Xtreme TX91 is beeping every second?
If the icon flashes on the LCD display and the alarm beeps every second on your Xtreme UPS, it could indicate that the external or internal batteries are incorrectly connected. Check if all batteries are connected properly.
Why is my Xtreme TX91 beeping every second and the fan isn't working?
If the icon flashes on the LCD display and the alarm beeps every second on your Xtreme UPS, it could indicate that the fan is locked or not working, or the UPS temperature is too high. Check the fans and notify your dealer.
Instructions on where and how to install the UPS system safely.
Procedures for electrical connection and grounding requirements.
Precautions and procedures for performing maintenance on the UPS.
Steps to unpack and inspect the UPS and battery pack upon arrival.
Identification of ports and components on the UPS rear panel.
Detailed instructions for electrical wiring and connection of the UPS.
How to connect external battery packs to the UPS unit.
Explanation of the UPS buttons, LED indicators, and LCD panel.
Detailed explanation of the LCD panel displays and information.
Descriptions of various operating modes like AC, ECO, CVCF, and Battery.
Procedures for turning the UPS on/off, connecting devices, and managing battery mode.
Lists warning and fault codes with their corresponding events.
A guide to diagnosing and resolving common UPS issues.
Technical specifications for the TX91 series UPS models.
Technical specifications for the TX91L series UPS models.
To Next Page
General
