The Tamper Detect report lists information for all TDLs (Tamper Detect Loops) or TDMs
(Tamper Detect Modules) that indicate that the meter has been tampered with. TDLs and
TDMs are connected to meters and report a condition of 1 to signify a tamper.
Tamper Summary
Available only with the PhonRead Protocol and printed either automatically or individually
from the Reports tab.
The Tamper Summary report lists all information (in summary format) from TDL (Tamper
Detect Loops) or TDM (Tamper Detect Modules) that are connected to meters. For both
a TDL and a TDM, a condition of 1 indicates a meter has been tampered with, whereas a
condition of 0 indicates no such tampering.
Units of Measurement Mismatch
Available in all protocols and printed either automatically or individually from the Reports
tab.
The Units of Measurement Mismatch report lists all accounts in which the units found during
the reading differs from the units imported from the billing system. To obtain this value
from a reading, the units of measurement must be programmed into an ECRIII register
and the register set to Extended Read Mode. OMNI registers will also transmit this value if
programmed into Extended Read Mode. Please note that both values need to exist for a
mismatch to generate.
Work Performed
Available in Handheld protocols only and may be set to print automatically or manually
printed from the Reports tab. Only applies to work order records loaded to a 5000 series
HHD.
9 Reports | 119
To Next Page
Loading...
Need help?
General
