EasyManuals Logo

Xyplex Terminal Server 720 User Manual

Default Icon
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
I/O and Cabling Considerations
3.2 RJ-45 Cabling Options
The 20-port I/O modules use modular cables that are designed for easy cable connections. The
cabling options available from Xyplex include (Chapter 6 lists the order codes for these items):
Crossover cables (male RJ-45 to male RJ-45, 10 and 25 feet)
Straight-through cables (male RJ-45 to male RJ-45; lengths: 1, 10, and 25 feet)
"Octopus" cables (a single 50-pin male or female Telco connector, or a 36-pin male or female
Telco DECconnect connector, fanning out to eight male RJ-45 connectors)
DECconnect crossover cable (male RJ-45 to male MMJ, 10 and 25 feet)
Modular adaptors:
- Female RJ-45 to male DB-25, supporting RING signal
- Female RJ-45 to male DB-25, supporting RTS/CTS flow control (Modems that
perform compression/decompression typically use this type of flow control.)
- Female RJ-45 to female DB-25
- Female RJ-45 to female MMJ
- Female RJ-45 to female RJ-45
- Male RJ-45 to female RJ-12
- Male RJ-45 to female MMJ
Customer cable-making kits
Standard cabling items available from Xyplex allow you to connect to any serial device that
uses a male or female DB-25 connector. All you need is the appropriate modular cable
(crossover cable for connecting to a DTE device, straight-through cable for connecting to a DCE
device), and the correct modular adaptor (male or female DB-25 connector), which is
essentially an RJ-45-to-DB25 adaptor.
Xyplex also supplies DECconnect-compatible crossover cables and modular adaptors for use
with the 20-port I/O modules. These cables are described later in Section 3.2.4
3.2.1 Making Your Own RJ-45 Cables
If you make your own cables, you should be very careful when using the crimping tool. Make
sure that the RJ-45 connector is fully inserted into the die set cavity of the crimping tool, and that
the wire is fully inserted into the RJ-45 connector, before crimping. The die set might be fragile,
and could break if the RJ-45 connector is not properly seated before you squeeze the handle.
Also, Xyplex recommends that you use different colored wires for straight-through and
crossover cables, in order to keep track of the cable type.
0021 3-23

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xyplex Terminal Server 720 and is the answer not in the manual?

Xyplex Terminal Server 720 Specifications

General IconGeneral
BrandXyplex
ModelTerminal Server 720
CategoryServer
LanguageEnglish