Configuration Menu
C.3.3 Option 3 - Initialize server and port parameters
To select this option, answer 3 to the "Enter menu selection" prompt of the Terminal Server
Configuration Menu (Figure C-1). The server prompts:
When the software has been loaded, should
default server and port parameters be used (Y,N) [N]?
Valid answers are Y (yes) and N (no). Type your answer and press RETURN; the unit
returns you to the Configuration menu.
The parameter initialization takes effect after you exit from the Configuration menu and the
unit loads its image (assuming that you specify that the unit should save the changes -- Option
S). Changes you have made through the ROM Configuration menu take place after you exit
from the menu.
If you decide that you do not want to revert to the initial values, you can again select Option 3
from the Configuration menu, and answer No to the preceding prompt, or exit without saving
the changes (i.e., select Option X).
C.3.4 Option 4 - Revert to stored configuration
To select this option, answer 4 to the "Enter menu selection" prompt of the Terminal Server
Configuration Menu (Figure C-1). The configuration menu prompts:
Revert to the stored configuration (Y,N) [N]? y
Valid answers are Y (Yes) and N (No). If you answer No, the unit returns you to the
Configuration menu. If you answer Yes, the unit displays the messages:
Configuration reset to stored values.
(Type any key to continue)
Press any key; the unit returns you to the Configuration menu (Figure C-1). You can then exit
from the Configuration menu using Option S or X.
C-76 0021
To Next Page
Loading...
General