Configuration Menu
Modify Unit Configuration Menu - Choice D.
If you select choice D of the Display Unit Configuration Menu, you will be prompted:
Initialize ALL configuration data for this unit to defaults (Y,N) [N]?
Valid answers are Y (Yes) or N (No). If you answer Y, all load/dump configurations and
miscellaneous settings (load messages enabled/disabled and amount of installed memory)
will be returned to their factory default settings. If you answer N, they will not be returned to
their factory default settings. After you have answered Y or N, the menu will prompt:
(Type any key to continue)
Press any key; the unit returns you to the Modify Unit Configuration Menu (Figure C-5).
If you answered Y, and the load/dump configurations and miscellaneous settings were
already at their factory default settings, you would see the message:
Configuration is already set to defaults
Modify Unit Configuration Menu - Choice X.
If you select choice X of the Display Unit Configuration Menu you will be returned to the
Terminal Server Configuration Menu (Figure C-5).
0021 C-75
To Next Page
Loading...
General