15
Transmission
1. While pressing and holding the PTT switch,
speak into the microphone.
TX/BUSY indicator lights red during the
transmission.
If the PTT switch is pressed when a frequency
other than the amateur ham radio band is
selected, an alarm tone (beep) will be emitted
and “ERROR” appears on the LCD, disabling
transmission.
Microphone
TX/BUSY Indicator
2. Release the PTT switch to return to receive mode.
When receiving a signal, the TX/BUSY Indicator lights green.
Changing the Transmission Power Level
Press and hold
the Function key
→
Press the
or
key
→
Press the Function key
(Enters the Set mode)
(Select Set Mode "40 TX PWR")
(Confirms the setting)
1. Press the [
] or [
] to select one of the following
transmission power levels.
TX PO Level Icon PO meter
HIGH (5W)
*
(off)
MID (2.5W)
LOW (0.5W)
* (The default setting.)
2. Press the PTT switch to save the setting and return to the normal
operation.
The transmission power level may be set separately for each frequency band.
To Next Page
Loading...
Need help?
General
