19
Registering to Memory Channels
1. Set the frequency and the communication mode.
That are to be registered to a memory channel.
2. Press and hold the [
V/M] key.
A blank memory channel will be displayed auto-
matically.
3. Press the [
] key or [
] key to select the desired
channel number.
4. Input the memory tag
Use the numeric keys to input the characters.
If not inputting a “Tag” (label), proceed to step 5.
Input Character
Example: Press the [2] key repeatedly to
toggle among the following available
characters.
2 → A → B → C → a → b → c → 2 →
Memory Channel
Number
Press the function key to move the cursor.
5. Press and hold the [
V/M].
The beep sounds and the memory is saved.
Memory Recall
1. While operating in the VFO mode, press the [
V/M] key to enter the
Memory mode.
The memory channel most recently used appears on the LCD.
2. Press the [▲] or [▼] key to select the desired memory channel.
When the transceiver is already set to the Memory mode, an easy way to
recall another memory channel is to enter the memory channel number
using the numeric keypad.
3. Press the [
V/M] key to exit the memory mode, and return to VFO
operation.
• To recall Memory Channel #200, enter “200”. To recall Programmable Memory
channels “L01/U01” through “L10/U10” enter “201/202” through “219/220”.
• The FT-4XR/XE may be set to operated only in the registered memory channels.
Press and hold the MONI/T.CALL key and the PTT switch simultaneously, while
turning the radio ON to enter the preferred operating mode.
In the preferred operating mode, press the [
] key or [
] key to select the [F5
M-ONLY], then press the function key to enter the Memory Channel Only mode.
To cancel the Memory Channel Only mode, press the [
] key or [
] key to
select the [F5 M-ONLY], then press the function key again.
To Next Page
Loading...
Need help?
General
