26
Using Set Mode
The Set Mode permits configuring the various functions according to individual
operating needs and preferences.
1. Press and hold the Function key.
The previously selected Set Mode item is
displayed.
2. Press the [▲] key or [▼] key to select the
desired Set Mode item.
3. Press the function key, then press the [
] key or
[
] key to change the setting.
4. Press the PTT switch to save the settings and
return to normal operation.
• In step 4 above, press the Function key to save the new setting and return to Set
Mode item in order to set another Set Mode item.
• On some setting screens, key operation is different than described in the
above steps (For example, inputting the characters, etc.). Refer to the Advance
manual.
For additional details, refer to the Advanced Manual which may be
downloaded from the Yaesu website
Tables of Set Mode Operations
No.
Set Mode
item
Description
Selectable options
(Options in bold are the
default settings)
1 APO
Sets the length of time until the transceiver
turns OFF automatically.
OFF / 0.5 Hours − 12
Hours
2 AR BEP
Sets the beep option during ARTS
operation.
OFF / INRANG / ALWAYS
3 AR INT
Sets the polling interval during ARTS
operation.
25 SEC / 15 SEC
4 BCLO
Turns the busy channel lockout function
ON/OFF.
BCL.OFF / BCL.ON
5 BEEP
Sets the beep function on pressing the
keypad, or stopping the receiver scanning.
KEY+SC / KEY / OFF
6 BELL
Selects the number of CTCSS/DCS/
PAGER/ARTS Bell ringer repetitions.
OFF / 1 T / 3 T / 5 T / 8 T /
CONT
7 CWID
Turns the CW Identifier ON/OFF during
ARTS operation.
TX OFF / TX ON
To Next Page
Loading...
Need help?
General
