EasyManuals Logo

Yaesu FT-4XR User Manual

Yaesu FT-4XR
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
29
Restoring to Defaults (Reset) / Setting the Preferred Operating Mode
The following reset or preferred operating modes may be selected.
1. Turn the transceiver OFF.
2. Press and hold the MONI/T.CALL key and the
PTT switch simultaneously, while turning the
transceiver ON.
3. When the LCD backlight comes on, release
the MONI/T.CALL key and PTT switch.
4. Referring to the below table, press the [▲] or
[▼] key to select the desired resets or desired
operating modes.
5. Press the Function key momentarily to activate
the selected operating mode.
Display Description
F1:SET.RST Resets the Set Mode settings to factory defaults.
F2:MEM.RST Clears the Memory settings to factory defaults.
F3:MB .RST Clears the Memory Bank assignments.
F4:ALL.RST Clears the all memories and other settings to factory defaults.
F5:M-ON LY Memory Mode operation only.
F6:CLONE Clone Mode.
CAUTION!
Resetting the transceiver (F2 MEM.RST / F4 ALL.RST) will clear all
memories.
Always make a note of the memory channel settings, etc. before
resetting.
To cancel this operation, turn the transceiver OFF.
Perform F4:ALL.RST to restore all of the following Set Mode items to default.
10 DCS.COD 26 PSWD 27 PSWDWT 30 RPT.FRQ 31 RPT.SFT
35 SKIP 36 SQL.TYP 37 STEP 38 TN FRQ 40 TX PWR
45 W/N.DEV

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yaesu FT-4XR and is the answer not in the manual?

Yaesu FT-4XR Specifications

General IconGeneral
BrandYaesu
ModelFT-4XR
CategoryTransceiver
LanguageEnglish

Related product manuals