To Next PageTo Next PageWhy is there no sound from the effect speakers on Yamaha DSP-A1?
If you are not hearing sound from the effect speakers on your Yamaha Amplifier, make sure the EFFECT button is turned on. Also, if you are using a Dolby Surround (or DTS) decoding program, ensure that the material you are playing is encoded with Dolby Surround (or DTS). If not, try using a different sound field program.
Why Yamaha DSP-A1 remote control transmitter does not work?
If your Yamaha Amplifier's remote control transmitter does not work, first replace the batteries with new ones and then press the RESET button on the remote control transmitter. If this doesn't work, the internal microcomputer may have frozen, in which case you should also try pressing the RESET button on the remote control transmitter.
What to do if the sound suddenly goes off on Yamaha DSP-A1?
If the sound from your Yamaha Amplifier suddenly goes off, the protection circuit may have been activated due to a short circuit. To resolve this, turn the unit into standby mode and then turn it back on to reset the protection circuit. Alternatively, the SLEEP timer may have been activated. If so, cancel the SLEEP timer function.
Why is there no sound or picture from my Yamaha DSP-A1 Amplifier?
If you are experiencing no sound or picture from your Yamaha Amplifier, begin by checking the output cord connections to ensure they are properly connected. If the problem continues, the cords may be defective. Verify that you have selected the correct input source using the INPUT SELECTOR or the TAPE 2 MON/EXT. DECODER button. Also, make sure the speaker connections are secure. Finally, ensure that the source you are playing is compatible with the unit.
General| Surround Sound | Dolby Digital, DTS, Dolby Pro Logic |
|---|---|
| Frequency Response | 10 Hz-100 kHz +0, -3 dB |
| Total Harmonic Distortion | 0.015% |
| Signal to Noise Ratio | 96 dB |
| Output | Pre-out |
| Speaker Load Impedance | 4-16 ohms |
| Digital Inputs | Coaxial, Optical |
| Video Inputs | Composite, S-Video |
| Dimensions | 171 mm |
| Input Sensitivity | 200mV (line) |
Essential safety guidelines for operation and maintenance.
The remote control unit for operating the amplifier.
Guidance on setting up speaker systems for optimal sound.
Description of front panel buttons, knobs, and indicators.
Selecting output modes for center, rear, main, and subwoofer speakers.
Procedure to adjust speaker output levels using test tones.
How to select and use DSP sound field programs.
Guide to fine-tuning output levels for individual speakers.
Solutions for common operating problems and symptoms.
