Operation
45
EMU28013
Procedure for tilting down (manual
tilt models)
1. Slightly tilt the engine up.
2. On models equipped with a tilt support
knob, pull it out.
3. Slowly tilt the engine down.
EMU28061
Shallow water
EMU28073
Cruising in shallow water (manual tilt
models)
EWM01781
● Run the boat at the lowest possible
speed when using the shallow water
cruising system. The tilt lock mecha-
nism does not work while the shallow
water cruising system is being used.
Hitting an underwater obstacle could
cause the outboard motor to lift out of
the water, resulting in loss of control.
● Use extra care when operating in re-
verse. Too much reverse thrust can
cause the outboard motor to lift out of
the water, increasing the chance of ac-
cident and personal injury.
ECM00260
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU28153
Procedure
1. Place the remote control lever / gear
shift lever in neutral.
69R-9-2A-1E0.book 45 ページ ２０１０年２月３日 水曜日 午後５時１８分
To Next Page
