Trouble Recovery
67
3. Remove the starter/flywheel cover after
removing the bolt(s).
4. Prepare the engine for starting. For fur-
ther information, see page 33. Be sure
the engine is in neutral and that the clip
is attached to the engine shut-off switch.
The main switch must be “ ” (on), if
equipped.
5. If equipped the choke knob, pull out it
when the engine is cold. After the engine
starts, gradually return the choke knob
to its home position as the engine warms
up.
6. Insert the knotted end of the emergency
starter rope into the notch in the flywheel
rotor and wind the rope several turns
around the flywheel clockwise.
7. Give a strong pull straight out to crank
and start the engine. Repeat if neces-
sary.
EMU33501
Treatment of submerged motor
If the outboard motor is submerged, immedi-
ately take it to a Yamaha dealer. Otherwise
some corrosion may begin almost immedi-
ately. NOTICE: Do not attempt to run the
outboard motor until it has been com-
pletely inspected.
[ECM00401]
69R-9-2A-1E0.book 67 ページ ２０１０年２月３日 水曜日 午後５時１８分
To Next Page
Loading...
